These topics include IPv4 and IPv6 network configuration, managing TCP/IP 1. Oracle Solaris TCP/IP Protocol Suite (Overview) The default is 10 seconds. Oracle Solaris Administration: IP Services Oracle Solaris 10 1/13 Information An IPMP configuration typically consists of two or more physical interfaces on the . For IPMP configuration tasks, refer to Chapter 31, Administering IPMP (Tasks). Oracle Solaris IPMP involves the following software: You can configure one of the interfaces down to 10 megabits and still place the two interfaces into the.
|Published (Last):||13 December 2016|
|PDF File Size:||16.61 Mb|
|ePub File Size:||3.27 Mb|
|Price:||Free* [*Free Regsitration Required]|
You use IPMP options of the ifconfig command to create the configuration. Solaris10 Self Paced Video Learning.
The interface can still be used for probe traffic. If you want the configuration to be invoked in the current session, do steps 1, 2, and, optionally, 5.
Internet Key Exchange Overview. Network access includes IPv4 unicast, multicast, and broadcast traffic, as well as IPv6 unicast and multicast traffic. You use IPMP options of the ifconfig command to create the configuration.
How to configure Solaris 10 Link Based IPMP
Failure Detection and Failover Failure detection is the process of detecting when an interface or the path from an interface to configjration Internet layer device no longer works. Thank you for reading this article.
For example, a qfe NIC can have four interfaces, qfe0 through qfe3and so on. Troubleshooting Network Problems Tasks.
Reboot the system after any changes to verify you have unique mac addresses now. Detaching NICs All requests to detach system components that configurafion NICs are first checked to ensure that connectivity can be preserved.
A subnet number or prefix cannot be assigned to more than one IP link. In IPv6, link-local addresses are not normally placed in the name service tables. IP Security Architecture Reference In this example, physical interface and data address are paired together.
Configuring an IPv6 Network Tasks 8. Address set to Therefore, you must configure only one IPMP group per subnet.
Rammeesh unix: IPMP in Solaris 10
Then, the standby interface is treated comfiguration same as other active interfaces until the failed interface is repaired. Failure detection is the process of detecting when an interface or the path from an interface to an Internet layer device no longer works.
IPMP Configuration – Solaris 10 vs Solaris 11 –
Administering Network Interfaces Tasks 7. Occasionally, a physical interface or the networking hardware attached to that interface might fail or require maintenance. Administering Network Interfaces Tasks 7. If no routers exist on the link, in. You can add new interfaces to an existing group on a live system. Probe-based failure detection involves the sending and receiving of ICMP probe i;mp that use test addresses.
How to configure Solaris 10 Probe based IPMP
The probe messages help to determine the health of each interface in the IPMP ipkp. Data Addresses Data addresses are confiuration conventional IPv4 and IPv6 addresses that are assigned to an interface of a NIC at boot time or manually, through the ifconfig command.
Make sure the NIC status are up and not in use. Instead, these failovers might choose an active interface with fewer data addresses that are configured as UP than the standby interface. For an introduction to test addresses, refer to Test Addresses.