GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Determining the (In-plane) Flow Rate per Unit Width and . ASTM D Test Method Determining the (in-plane) Flow Rate Per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head. Last previous edition approved in as D – 2. For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer.
|Published (Last):||7 November 2005|
|PDF File Size:||20.38 Mb|
|ePub File Size:||6.9 Mb|
|Price:||Free* [*Free Regsitration Required]|
For the best results, we recommend including the following details: Competent statistical assistance is recommended for the investigation of bias.
Products – BT Technology
Send your message to this supplier. If bias is e4716, either its cause must be found and corrected or the purchaser and supplier must agree to interpret future test results in light of the known bias. Your message has been sent to the following suppliers. Combining values from the two systems may result in non-conformance with the standard. Your email address is incorrect! Inquiry Sent Successfully Confirmation email has been sent: The test specimens should then be randomly assigned in equal numbers to each laboratory for testing.
Link to Active This link will always route to the current Active version of the standard. Enter your email please.
The flow of water within the plane of a geotextile or geotextile-related product is measured under varying normal compressive stresses, with typical hydraulic gradients and with defined contact surfaces. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Recommended Quality Verified Suppliers.
Forward Filter Manufacturers Co. Historical Version s – view previous versions of standard. Pressure Pump and Testing Cylinder Easy to operate, the result more accurate. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. I would like your verified suppliers matching service! Application Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product.
Site Member 3 Years.
Please enter 20 to characters to contact this supplier! Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product.
Geotextile Water Flow Capacity Tester ASTM D4716
Your message must be betweencharacters! Please reply me widthin 24 hours. Features Diaphragmpressurizing High pressure, Keeping pressure long time, easy to maintain, can greatly reduce the testing cost.
Comparative tests as directed in 5.
The test is intended primarily as an index test but can be used also as a performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated field conditions. The average results from the two laboratories should be compared using the Student’s t -test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun.
As a minimum, the two parties should take a group of test specimens that are as homogenous as possible and that are formed from a lot of the material of the type in question. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Please reply me within 24 hours.